GRIT Pneumatic Retrofit Gate Control
Gate Control
Turn an existing 12–24V DC pneumatic gate into a GRIT-controlled device.
The GRIT Pneumatic Retrofit Gate Control opens and closes an existing pneumatic gate automatically when a GRIT Trigger detects that an associated tool is running. The GRIT Hub coordinates the sequence over the GRIT mesh network, while an LED on the control box shows gate status at a glance. The pneumatic gate, cylinder, solenoid valve, and air components are not included; this product is the GRIT retrofit control module only.
Key Features
- Pneumatic retrofit: Adds GRIT control to an existing pneumatic gate without replacing the gate, cylinder, or valve.
- Hub-coordinated: Opens and closes the gate automatically in response to mapped tool activity.
- Three control modes: Supports spring-return, dual-solenoid pulse, and diverter A/B operation.
- 12–24V DC power: Works across the DC voltage range used by most pneumatic gate solenoids.
- Status LED: A visual indicator on the control box shows gate status.
- Wireless pairing: Connects to the GRIT Hub over the GRIT mesh network.
Specifications
- SKU GA-GC5001
- Gate Type Pneumatic gate with compatible DC solenoid valve
- Power 12–24V DC
- Control Modes Spring-return, dual-solenoid pulse, diverter A/B
- Wiring 18/2 solid copper thermostat wire
- Status Gate-status LED
- Connectivity GRIT mesh network to GRIT Hub
In the Box
- 1x GRIT Pneumatic Retrofit Gate Control (GA-GC5001)
- 1x length of 18/2 solid copper thermostat wire
- 1x VHB mounting tape
Compatibility
For pneumatic gates using a compatible 12–24V DC solenoid valve. Use spring-return mode with a single-coil 5/2 valve such as the tested 4V210-08; use dual-solenoid pulse mode with a dual-coil 5/2 valve such as a 4V220-08. Diverter A/B uses the same pulse control to select between two duct paths. Not compatible with AC coils or coils outside 12–24V DC. A 5/3 valve may have a center position, but the GRIT Hub does not provide a separate center command.
Installation
Mount the control box near the existing valve, connect the 12–24V DC supply and solenoid leads with the included 18/2 thermostat wire, and select the matching control mode in the Hub. Confirm open and closed operation, then pair the Gate Control with the Hub through the GRIT App.
*GRIT Hub or Hub Pro is required for device functionality.
Important Notes
Verify the valve coil voltage, DC power requirement, and single- or dual-coil configuration before ordering. Pneumatic gate, solenoid valve, air components, and DC power supply are not included. Gate Controls in Pro GRIT Track systems are subject to a 20% software upgrade charge — contact GRIT for details.